11
2.
Turn both the Focus Mode Lever and ON/OFF Switch control forks
so they line up with the corresponding camera controls.
3.
Place the back onto the housing front.
4.
Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
5.
Place each lid snap into the corresponding hook on the housing
back.
6.
Push the lid snaps towards the housing until they are flat against
the housing and the lock has engaged. Close opposing lid snaps at
the same time.
7.
Check the o-ring seal. The o-ring should form a uniform, solid line
around the back of the housing. There will be a small, even gap
around the housing between the housing back and the housing
front.
Even Gap on
All Sides
Housing Back
Main O-ring
Lid Snap
Lid Hook
8.
Check camera control functions with the housing controls.
Attaching the Lens Port
A compatible lens port is required for waterproof operation.
Never submerge the housing without a lens port attached.
