8
U
Ussiinngg tthhee CCaam
meerraa’’ss BBuuiilltt--iinn FFllaasshh
For the best results, we recommend using an external Ikelite
Substrobe. If you do not have an external flash, the camera’s
built-in flash can be used. This use is limited due to the housing
port blocking a porion of the built-in camera flash. See
Diffuser/Deflector Installation (page 9).
NOTE: The camera’s built-in flash cannot be used with optional
Wide-Angle or Accessory lenses.
6
7
5
CChheecckk M
Maaiinn O
O--rriinngg SSeeaall aanndd CCoonnttrroollss
Once the housing has been closed, look at the main housing o-ring
seal from the “top view” as seen on page 4. Rotate the housing 360
degrees and note the o-ring seal by looking through the clear
housing. A good seal should appear as a solid black line.
H
Hoouussiinngg CCoonnttrroollss
Make sure the housing controls line up with the camera controls.
Turn the camera on and operate each of the housing controls to
get a feel for using the camera in the housing. Take a few pictures
above water with the camera in the housing.
- All camera controls are accessed except the rear Control Dial.Use
arrow pad instead to change menu settings.
Control Ring
Tray Mount
Lens Port
Front View
Shutter
Button
Power Button
Mode Dial
Ring Function
Zoom
Lever
Back View
Lanyard
Latch
ULTRA
compact
Made in USA
IKELITE
[1] Short Cut
[2] Playback
[3] +/-
[4] Macro/MF
[5] FUNC./SET
[6] Flash
[7] Single Erase
[8] Display
[9] Menu
1
4 5
3
7
6
2
9
8
Zoom Control:
After you have used the housing's zoom control,
it must be returned to the
center position to
disengage. If the housing
zoom control is pushing
the zoom lever in either
direction, you may not be
able to take a picture or
access other functions. This
is because the camera is
receiving a signal from the
engaged zoom control.
++
--
++
--
Zoom Control Disengaged
“Center Position”
Zoom Control Engaged
H
Hoouussiinngg CCoonnttrroollss
((ccoonntt..))
CClloossiinngg tthhee H
Hoouussiinngg
1. Place housing face down in your lap or on a flat surface.
2. Check to see that there is an o-ring on the housing back and
that it is clean, lightly lubed, and in its proper location.
3. Rotate the hinged back onto the housing front. Close the latch
and make sure it locks. Latch will “click” into it’s locked position.
Latch buttons will NOT be depressed when latch is properly
locked.
ULTRA
compact
Made in USA
IKELITE
Latch in “locked”
position
Latch Button
Latch Button
H
Hoouussiinngg CCoonnttrroollss
((ccoonntt..))
CClloossiinngg tthhee H
Hoouussiinngg
IInnssttaalllliinngg tthhee CCaam
meerraa
1. Place the camera face down into the front housing ribs as
shown.
Camera in Housing Front
C
anon
o-ring
Housing Back - Top View
