This light coating of lubricant will help to keep the o-ring from drying out
and will help to show a dark sealing line when the housing back is properly
sealed.
- Keep area where the o-ring fits and sealing surface of the housing clean.
- Rinse the housing exterior thoroughly in fresh water after each saltwater
use. Depress push buttons repeatedly in fresh water to eliminate trapped
saltwater. Dry with a soft cloth. Dry lens port to eliminate water spotting.
After several uses in saltwater, soak the housing exterior in a mild soap
solution; rinse and dry before storing. When storing the housing, remove
the back o-ring, lightly lubricate, and place in a plastic bag. Place the plastic
bag with o-ring inside the housing for safe keeping.
- If removing a housing push button, Do Not re-use the E-clip. Contact Ikelite
for replacement E-clips (part 0319.12).
- Leave lid snaps in the open position when not using the housing for
extended periods.
- Always disassemble and clean optional Tray/Handle(s) before storage.
Housing Maintenance - continued
Control Maintenance
Ikelite controls are designed to provide years of reliable service with
minimal maintenance.
- Push button controls normally require no maintenance other than rinsing
in freshwater after saltwater use. Depress each push button in fresh
water several times to eliminate trapped saltwater. If a push button control
becomes difficult to push or if it sticks when depressed, soak the housing in
luke warm fresh water. After a few minutes, operate the push button. If this
does not correct the problem, return the housing to Ikelite for maintenance.
If you are on a trip and unable to return the housing immediately, a push
button may be lubricated by pressing and holding the push button all the
way in. Then, use your finger or other small non-metal object to place a
small amount of lube at the base of the shaft inside the housing.
22
