17
2.
Place a small amount of lubricant at the base of the push button
shaft inside the housing.
3.
Press and release the push button several times to work the
lubricant into the o-ring.
4.
If a push button control becomes difficult to push or if it sticks when
depressed, soak the housing in warm, soapy fresh water. After a
few minutes, operate the push button. If this does not correct the
problem, return the housing to Ikelite for maintenance.
»
To prevent build-up of salt, sand, or debris, the push buttons
should be flushed with fresh, clean water after every use.
Depress each push button while the housing is submerged in
fresh water.
»
If it is necessary to remove a housing push button, NEVER
re-use the e-clip. Push button o-ring kits include replacement
e-clips.
»
Push buttons look similar but vary in length. Remove and re-
install one push button at a time.
Lubricating Control Shafts
1.
Loosen the knob set screw using a hex key. Some set screws are
covered by a vinyl sleeve. The vinyl sleeve must be removed prior
to loosening the set screw.
2.
Remove the control shaft from the inside of the housing.
