TM10-17RA
10-inch Broadcast Color Monitor
!
Specifications
"
"
"
"
GENERAL
Input Voltage
100~/-10%, 50/60Hz,
Single Phase (JPN, USA)
200~/-10%, 50/60Hz,
Single Phase(EUROPE)
(Switchable from a remote connector.)
Power Consumption
Approx.40W(Standard)
Ambient Temp.
0~+40'C, 90% or less relative
Humidity(non-condensing)
Dimensions (WHD)
222(W) x 213(H) x 352(D) mm
(8.7 x 8.4 x 13.9 inches)
Weight
Approx. 10kg (22 lbs.)
"
"
"
"
RATING
Input Signal
Video: 2 inputs
Y/C: 1 input
RGB/Y,Pb,Pr: 1 input
*Switchable at rear panel
Digital Video: 1 input (Option)
Sync: 1 input
Input Level
Video Signal: Composite 1.0Vp-p
Non-composite 0.7Vp-p
Y/C Signal: Y Signal 1.0Vp-p
C Signal 0.286Vp-p(burst)
RGB or Y, Pb, Pr:
[RGB Signal]
G signal 1.0Vp-p(sync on green) or
0.7Vp-p
R/B signal 0.7Vp-p
[Y,Pb,Pr Signal]
N10/SMPTE Format
Y 1.0Vp-p(sync on green) or 0.7Vp-p
Setup: 0Vp-p
Sync: 4Vp-p+/- 2Vp-p
Pb,Pr: 0.525Vp-p
Digital Video:
[D1]CCIR Rec.601 (4:2:2 Format)
[D2,D3]SMPTE standard
Sync Signal: Composite Sync 4Vp-p
Connection
Video/RGB or Y,Pb,Pr:
Bridging BNC connectors, high imp-
Edance with 75ohm termination SW.
Y/C: 4pin plastic connector, single end
75 ohm terminated. (7pin metal
connectors are OPTION)
Remote Controls
a)Video input select
(A/B/YC/RGB or Y,Pb,Pr, Digital)
b)COLOR/MONO select
c)Tally ON/OFF
d)16:9
e)Sync INT/EXT
"
"
"
"
PERFORMANCE
CRT
In Line-gun, dot mask, High-resolution
CRT
Dot Pitch
0.28mm
Resolution(at center)
More than 450TV Lines
"
"
"
"
VIDEO SIGNAL SYSTEM
Frequency Response
Measured with aperture gain 0
60Hz~5MHz: flat 1/-3dB
Chrominance Rejection
Less than -24dB(with aperture correction 0
Ratio Noise
Coherent noise: Less than -40dB
Other noise: Less than -50dB
"
"
"
"
COLOR SIGNAL SYSTEM
Demoduration Axis
R-Y, B-Y system
Frequency Response
3.58MHz +/-0.5MHz +/-3dB
(measured at chroma output test point)
"
"
"
"
SYNC SYSTEM
Sync Stability
Stability of sync will be met for the
Following conditions.
a)Internal
Sync
Video input level /-6dB against the
rated value of 1.0Vp-p.
b)External Sync
Sync signal input level of 1.0~8.0Vp-p.
AFC Time Constants
SLOW: Approx. 2.0msec.
FAST: Approx. 0.5msec.
"
"
"
"
DEFLECTION SYSTEM
Scanning Frequency
Horizontal
Normal 15.734KHz
Vertical
Normal 59.94Hz
Scanning Amplitude
Normal Scan
Overscan is 1% of CRT effective area with
An aspect ratio of 4:3
Underscan
-14% of normal scan
Geometry and Linearity
Less than 2% of picture height
Convergence error
Center
Inside a circle with diameter of 80% of
Picture height: Less than 0.5mm
Corners
Outside area of picture center: Less than
1.0mm
"
"
"
"
HIGH VOLTAGE
Tolerance
18KV+/-1KV
Regulation
+/-5% over the range of 0~300uA referred
To 100uA.
"
OPTIONAL ACCESSORIES
DK-1073A
D1 Module Kit
DK-1074NA
D2/D3 Module Kit (NTSC)
DK-1074PA
D2/D3 Module Kit (PAL)
SF-1071
Special Function Module
SRC-301
Serial Remote Controller
DR-1016
19" Dual Rack Frame
BP-1016
One Half Rack Wide Blank Panel
WR-1016
19" Rack Frame for one Teck Scope
DC-10172
DC12~24V Input Module
IM-1017
Instruction Manual
OMC1017
Operation Manual
Design and specifications are subject to change without notice.
Ikegami Electronics (U.S.A.) Inc.
Headquaters 37 Brook Avenue, Maywood, NJ 07607 Phone: (201)368-9171 Fax: (201)569-1626
Westcoast office 2631 Manhattan Beach Blvd.., Redondo Beach, CA 90278 Phone: (310)297-1900 Fax (310)536-9550
Southwest office 526 Bluebird Lane, Red Oak, TX 75154 Phone: (972)869-2363 Fax: (972)556-1057
Midwest office 747 Church Road, Unit C1, Elmhurst, IL 60126 Phone: (630)834-9774 Fax: (630)834-8689
Southeast office 5200 N.W. 33rd Avenue, Suite 111, Ft. Lauderdale, FL 33309 Phone: (954)735-2203 Fax: (954)735-2227
