IKEA 204.620.52, Manual

Page: 33 / 80

33
EN
CARE AND CLEANING
Removing and Replacing the Oven
Door
figure 15: Door hinge location
Oven door
hinge
locations
figure 16: Door hinge Locks
figure 17: Holding door for removal
figure 18: Replacement and location of
hinge arm and roller pin
To remove the oven door:
1. Open oven door completely, horizontal with floor.
2. Pull the door hinge locks on both left and right
door hinges down from the oven frame complete-
ly towards the oven door (See Figure 16).
A tool such as a small flat-blade screwdriver may
be required.
3. Firmly grasp both sides of oven door along the
door sides. Do not use the oven door handle
(Figure 17)
4. Close the door to approximately 10 degrees from
the door frame (Figure 17).
5. Lift the oven door hinge arms over the roller pins
located on each side of the oven frame
(Figure 18)
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the
door sides. Do not use the oven door handle
(Figure 17).
2. Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm
over the roller pins located on each side of the
oven door frame (See Figure 18). The hook of
the hinge arms must be fully seated onto the
roller pins.
3. Fully open the oven door, horizontal with floor
(Figure Figure 155).
4. Push the door hinge locks up towards and into
the oven frame on both left and right oven door
hinges to the locked position (Figure 166).
5. Close the oven door.
roller
pin
hinge
arm
LOC
K
about
10°
hinge
oven
door
IMpORTANT
Special door care instructions - Most oven doors
contain glass that can break. Do not hit the glass
with pots, pans, or any other object. Scratching, hit-
ting, jarring, or stressing the glass may weaken its
structure, causing an increased risk of breakage at
a later time. Do not close the oven door until all of
the oven racks are fully in place
.
CAUTION
The door is heavy. For safe, temporary storage, lay
the door flat with the inside of the door facing down.