29
RETCV_0107
Check whether the voltage specified on the type plate mat-
ches the mains voltage available. The power socket used must
be earthed (protective earth conductor contact). Insert the
temperature measuring sensor (not included in the supply
schedule) into the 5-polar DIN-bushing at the rear of the instru-
ment. Put a magnetic bar into a vessel that is permeable for
magnetic field lines, and fill the vessel with the medium to be
processed. Put the vessel on the heating plate and immerse
the temperature measuring sensor into the medium (min.
20mm). Wit the enterprise without external temperature mea-
suring sensor see chapter 11.3. If these conditions are met,
the device is ready to operate after plugging in the mains plug.
If these procedures are not followed, safe operation cannot be
guaranteed and/or the equipment may be damaged.
Observe the ambient conditions (temperature, humidity, etc.)
listed under Technical Data.
foil key Mot
foil key Temp
LED Mot
foil key Mode
digital display
foil key
Visc
LED Temp
rotary knob Mot
rotary knob Temp
Commissioning
5
Control elements
6
When the functions are switched off, the digital display always
shows the set speed value.
Mains switch
Display
7
I
ll. 1
real value
rated value
e.g. phys. unit,
mode of operati-
on, error
code
mode of
operati-
on B or
C
Process value; (real value)
function started
Set value
(rated value)
Pt 100 or
Pt 1000
PC-control
In all three modes of operation only function “heating” has
been started, the display shifts to rated and real temperature.
In all three modes of operation only function “stirring” has
been started, the display shifts to rated and real speed.
Summary of Contents for WERKE IKAMAG RET control-visc
Page 105: ...104 RETCV_0107 ...
Page 106: ...105 RETCV_0107 ...
