IKA ULTRA -TURRAX Tube Drive P control, Operating Instructions Manual

Page: 25 / 96

25
Error codes 13
Maintenance 14
The drive unit is maintenance-free but not immune from wear. The
carbon brushes of the motor wear down over the time.
For cleaning disconnect the main plug.
Only use cleansing agents which have been recommended by IKA .
Dirt Cleaning agent
Dyes isopropyl alcohol
Construction materials water containing tenside/isopropyl alcohol
Cosmetics
water containing tenside/isopropyl alcohol
Foodstuffs water containing tenside
Fuels water containing tenside
For materials which are not listed, please request information from
IKA application support.
Wear protective gloves during cleaning the instruments.
Electrical instruments may not be placed in the cleansing agent for
the purpose of cleaning.
Do not allow moisture to get into the instrument when cleaning.
Before using another than the recommended method for cleaning
or decontamination, the user must ascertain with
IKA that this
method does not destroy the instrument.
Spare parts order:
When ordering spare parts, please give:
- machine type
- manufacturing number, see type plate
- item and designation of the spare part, see
www.ika.com ,
spare parts diagram and spare parts list.
 Turbo function will be stopped and rotation speed will return
to original setting. A symbol appears to indicate that the
Turbo function is stopped. Before this symbol disappears,
turbo function can not be activated again.
Any malfunction during operation may be identified by an error
message on the display.
Proceed as follows in such cases:
 Switch off device using the power switch
 Carry out corrective measures
 Restart the device.
Error
code
Cause Effect Solution
Error 3 Inside temperature is
too high motor off - Switch off the device and
let it cool down.
- Restart the device.
Error 4 Motor can’t run normal
(can’t start or not reach
the target speed) motor off - Switch off the device.
- Check the structure for
possible blockades
Error 47
Error 48
Overload motor off - Switch off the device
- Decrease the speed setting
or the load
Error 50 Tube is protected in
order to avoid overload motor off - Check the tube condition
- Decrease the speed setting
or the load
If the actions described fails to resolve the fault or another error
code is displayed then take one of the following steps:
- Contact the service department
- Send the device for repair, including a short description of the fault.