28
/// Lock button
› An active locking is indicated by the symbol (
)�
› Even after a power failure, the device retains the lock status�
Timer mode (count down):
› Set the desired value with the rotating / pressing knob (D)� By pressing the knob the value is
confirmed�
› Pressing the button (F) to start the timer�
› To pause the timer, press the button (F)�
› To restart the timer, press the button (F) again�
› After the timer has elapsed, the display starts flashing and a beep sounds (depending on the
menu setting)�
Counter mode (count up):
› To select the counter mode, you must set all the values to 00:00:00�
› The value is confirmed by pressing the rotating / pressing knob (D)�
› Pressing the button (F) to start the counter�
› Press the button (F) to pause the counter�
› To restart the counter, press the button (F) again�
› If the elapsed time exceeds the value of 100 hours, the display switches from hour:minute:sec-
ond mode to day:hour mode�
› If the elapsed time exceeds the value of 100 days, the counter will reset to 00:00:00�
!
Notice!
› From each state of the timer / counter, press the button (F) for 2 seconds to exit the timer /
counter�
Temp 0...310 °C
Speed 0...1500 rpm
SET
SET
SAFE
Summary of Contents for Plate RCT digital
