It is not possible to carry out pH measurements in metal containers.
The
ETS-D6
is not suitable for diagnostic measurements for medi-
cal purposes.
•
Range of use
- Laboratories
- Schools
- Pharmacies
The protection for the user is not ensured no more, if the equip-
ment with accessories is operated, which are supplied or are not
recommended not by the manufacturer or if the equipment in not
correct use is operated against the manufacturer default.
•
Unpacking
- Please unpack the device carefully
- In the case of any damage a detailed report must be set imme-
diately (post, rail or forwarder)
•
Content of package
-
ETS-D6
- Operating instructions
+
Plug the instrument into the contact thermometer jack on the
heating magnetic stirrer or heating device , e.g.
IKA:
RCT basic, IKA RET basic, RH basic KT/C,
RH digital KT/C, HCT basic
Heidolph: MR3001K, MR3002
VWR:
VMS-D, VWR VMS-A
H+P Variomag
Please observe all safety instructions in this respect.
Connecting a
“Corning” magnetic stirrer:
+
Turn the rotary "heat" dial on the magnetic agitator to the "O"
(off) position. Next, connect the
ETS-D6
to the magnetic agita-
tor using the AD-C1 adapter provided.
Please observe all safety instructions in this respect.
ã
The device will be activated when the magnetic agitator is swit-
ched on.
If the supply voltage at the contact thermometer connector is not
between 8 Vdc and 16 Vdc then it will be necessary to power the
device using the H 52 power supply set (H 50 double connector
adapter and H 51 plug-in power supply unit). The power supply
and/or double connector adapter will provide the necessary supp-
ly voltage for the device. An automatic self-test will be performed
when the device is activated. An introductory screen will be shown
on the LCD display, see fig. 5.
+
Connect the BNC-connector for the pH-probe to the BNC-
socket on the rear of the unit and lock in place using the bayo-
net fitting, see fig. 3.
+
Pull the sensor and protective cap downwards, see fig. 4
ã
The plastic snap fastener is released
+
Push the sensor or extension cable and protective cap over
the fitting on the instrument
ã
The connection is re-established
ã
LCD display see fig. 28
18
012007
Commissioning
Unpacking
Connecting the pH-probe
Replacing extension cable and
temperature sensor
