IKA G-L, Manual

Page: 12 / 15

22 23
Maintenance and cleaning
The device is maintenance-free� It is only subject to the natural wear and tear of components and
their statistical failure rate�
/// Cleaning:
For cleaning disconnect the mains plug!
Use only cleaning agents which have been approved by IKA to clean the devices�
Dirt Cleaning agent
Dyes Isopropyl alcohol
Building materials Water containing detergent / isopropyl alcohol
Cosmetics Water containing detergent / isopropyl alcohol
Food Water containing detergent
Fuels Water containing detergent
› For materials which are not listed, please request information from IKA application support�
› Wear protective gloves during cleaning the devices�
› Electrical devices may not be placed in the cleansing agent for the purpose of cleaning�
› Do not allow moisture to get into the device when cleaning�
› Before using another than the recommended method for cleaning or decontamination, the
user must ascertain with that this method does not destroy the device�
/// Ordering spare parts:
When ordering spare parts, please indicate:
› device type�
› serial number, see type plate
› item and designation of the spare part, see:
www.ika.com , spare parts diagram and spare
parts list�
› software version (Briefly visible in the display when the device is switched on)�
/// Repairs:
Please send in device for repair only after it has been cleaned and is free from any
materials which may constitute a health hazard.
For repair, please request the “Decontamination Certificate” from IKA , or download printout of
it from the IKA website www.ika.com �
If you require servicing, return the device in its original packaging� Storage packaging is not
sufficient� Please also use suitable transport packaging�
/// Emergency opening lid
In an emergency, you can open the protective cover as described below:
› Disconnect the device from the power source�
› Make sure the rotor has come to a standstill�
› Lift the device and open the protective cover by turning the mechanical latch in counterclock-
wise with a suitable tool (e�g� a slotted screwdriver)�
1.
2.
Note! ( )
When lifting up the device, particularly after a device failure, please note that the motor on the
underside of the device can become very hot� Touch the device at the edges only!
Please also take care of the samples inside the rotor� The samples may spill out while lifting the
device�