ENGLISH
BEFORE YOU OPERATE THE MONITOR 17
CONNECTING YOUR MONITOR
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the Power Cable to the monitor first and then to the power source.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
Make sure you tighten the finger screws at each end of the Signal Cable.
When USB cable connected than wait for 5 seconds and the touch function is ready to
go. It can be activated by pen, finger or any other pointer.*
Excessive sound pressure from ear-/headphones can cause hearing damage/hearing loss.
[Example of Connection]
<Back>
NOTE
* Cable is not supplied with the monitor. If you use low quality Cable, it may cause a result of electro-
magnetic interference. Please contact the iiyama Support Centre in your country if you wish to connect
the monitor via the VGA or DVI input.
Router
Computer
AV Equipment
VGA Cable (Not Included)*
HDMI Cable (Accessory)
Power Cable (Accessory)
USB Cable (Accessory)
Audio Cable (Not Included)
HDMI Cable (Not Included)
DVI-D Cable (Not Included)*
DisplayPort Cable (Accessory)
RS-232C Cable (Not Included)
IR Extender Cable (Accessory)
LAN(RJ45) Cable (Not Included)
