Iiyama ProLite LH9852UHS, User Manual

Page: 22 / 54

ENGLISH
18 BEFORE YOU OPERATE THE MONITOR
CONNECTING YOUR THE MONITOR
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the RS-232C Cable.
Connect the Power Cable to the monitor first and then to the power supply.
Turn on your monitor (Main Power Switch and Power Switch) and computer.

The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.

For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.

Make sure you tighten the finger screws at each end of the Signal Cable.

The Class I pluggable equipment Type A must be connected to protective earth.

The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
<Back>
NOTE
* VGA cable is not supplied with the monitor. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the VGA input.
or
Computer
AV Equipment
VGA Cable
(Not Included)*
DVI-D Cable
(Accessory)
HDMI Cable (Accessory)
Power Cable (Accessory)
RS-232C Cable
(Accessory)
Audio Cable (Not Included)
HDMI Cable (Not Included)
Notebook
GAME
Equipment etc.
DisplayPort
Cable
(Accessory)
mDP-DP
Cable
(Accessory)