ENGLISH
BEFORE YOU OPERATE THE MONITOR 21
CONNECTING YOUR THE MONITOR : ProLite LH8642UHS
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer with the RS-232C Cable from the monitor.
Connect the Power Cable to the monitor first and then to the power source.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
Make sure that the building installation has a circuit breaker of 120/240V, 20A (maximum).
The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama office.
Make sure you tighten the finger screws at each end of the Signal Cable.
The Class I pluggable equipment Type A must be connected to protective earth.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
<Back>
NOTE
Computer
AV Equipment etc.
VGA Cable (Not Included)*
DisplayPort Cable
(Not Included)
HDMI Cable (Not Included)
Power Cable (Accessory)
RS-232C Cable (Accessory)
Audio Cable (Not Included)
GAME
Equipment etc.
HDMI Cable (Accessory)
DVI-D Cable
(Not Included)*
* Cable is not supplied with the monitor. If you use low quality Cable, it may cause a result of electro-
magnetic interference. Please contact the iiyama Support Centre in your country if you wish to
connect the monitor via the VGA or DVI input.
