Ihse kvm-tec KT-6014, User Manual

Page: 23 / 84

kvm-tec | 23
Misprints, errors and technical changes reserved Misprints, errors and technical changes reserved
2. INSTALLATION EXTENDER
2.2 MOUNTING OPTIONS
2.2.1 MOUNTING PADS AND RUBBER FEET
The mounting pads and rubber feet can be used to hold the extenders in place and prevents
them from sliding and falling.
To attach the mounting pads or rubber feet:
1. Remove the protection layer from the mounting pads or rubber feet (G).
2. Attach the mounting pads or rubber feet (G) to the bottom the units.
2.2.2 MOUNTING KITS (OPTIONAL)
The following mounting kits are available:
Rackmounting kit RMK-FLEX-F Part Nr. KT - 6232 RMK-FLEX-F
Rack mounting kit RMK-F for mounting FLEXline Extender. 4 Single or Dual Extender. It
consists of a19“ rack shelf and an alu-faceplate.
Rackmountingkit RMK- FLEX- FN - T Part-Nr. KT - 6232 RMK- FLEX-FN
Rack mounting kit RMK-F for mounting FLEXline Extender. 4 Single or Dual Extender. It
consists of a19“ rack shelf and an alu-faceplate and a power supply
Under table mounting kit Part Nr KT - 6231 UMK-FLEX
The Under Desk Mounting kit is for underdesk mounting of FLEXline Extender.
Din rail Mounting Part-Nr. KT - 6235 DINMK-FLEX
The DIN rail mounting is used for space-saving installation in control cabinets or on DIN rails.
The attachment to the MA extenders is possible in several ways.
Vesa Mounting Part-Nr. KT - 6236 VH-FLEX
The robust VESA mounting is used to attach an extender to a monitor with existing VESA
mounting points. The Extender becomes one unit with the monitor and saves a lot of space and
cable clutter. The VESA mounting kit can be combined with an existing monitor mounting.