INSTALLING GLASS DOOR, BARRIER,
AND MODESTY PANEL
See WARNINGS and CAUTIONS on other side.
NOTICE: Only doors certified with the appliance shall be used.
AVIS : Seules des portes certifiées pour cet appareil doivent
être utilisées.
Note: These instructions do NOT apply to the outer glass door
provided in the Outdoor Kit for indoor/outdoor installations of
Montebello See-Through models.
1) Install glass door, as follows:
a) Retrieve the glass door. Visually inspect the gasket on the back of
the frame. Gasket surface must be clean, free of irregularities, and
seated firmly.
b) Position the door in front of the firebox opening, with the top of the
door held away from the fireplace (see
Figure 1
on other side).
c) Lower the bottom of the door assembly onto the bottom door track,
engaging and centering it in the base channel, and then gently swing
the door up.
d) Using a #3 Phillips screwdriver, fasten the door frame to the door
latches with the two (2) latch screws. The latches should pull forward
to engage the door frame.
Note: Securely tighten latch screws when reinstalling glass door
assembly.
INNOVATIVE HEARTH PRODUCTS • DRT/DRC6300
DIRECT-VENT GAS FIREPLACES • DOOR REMOVAL/INSTALLATION INSTRUCTIONS
P/N 900347-00 Rev. NC 12/2014
1508 Elm Hill Pike, Suite 108
Nashville, TN 37210
IHP.US.com
Innovative Hearth Products reserves the right
to make changes at any time, without notice,
in design, materials, specifications, prices and
also to discontinue colors, styles, and products.
Consult your local distributor for fireplace
code information Printed in U.S.A. © 2014
Innovative Hearth Products, LLC .
P900347-00
2) Install the modesty panel on the top flange of the glass door, as follows:
a) Grasp the modesty panel with both hands (with the open hem facing
down).
b) Engage it with the upper lip of the glass door frame by pushing it
all the way down. Make sure the installed modesty panel is firmly
in place.
3) Install the barrier, as follows:
a) Slide the barrier, flat side toward the fireplace, into the right barrier
bracket with gap below.
b) Reinsert the lower filler piece by sliding the tab behind the barrier.
c) Center the barrier between the left and right barrier brackets and
lower the barrier until the lower filler piece and barrier are flush with
the bottom of the glass door.
f i r e - p a r t s . c o m
