IHP.us.com
900861-00D
12
If you have determined to install the fireplace as a see-through
model then you will need to remove the rear back panel to convert
it. Before removing the rear back panel be sure to remove the
contents out of the firebox area. NOTE: The fireplace is shipped
with glass windshields and parts prepackaged inside the firebox
area that can interfere with removal of the rear panel.
CAUTION: WATCH FOR SHARP EDGES.
Figure 9 - Removing back wall to convert to see-through model.
Use the following steps:
NOTE: The numbers of screws to remove will vary with each fire-
place model.
Step 1. Look at the back side of the fireplace. Around the outer
perimeter area of the frame or back wall are several screws to
remove (See the shaded area in Figure 9). Only remove the top and
bottom screws on the rear panel. The naling flange will remain in
place. The back panel will remove as one panel. The number of
screws removed will vary with each fireplace model.
NOTE: Nailing fin will be loose when removing the top screws.
Secure the nailing fin back into place after back panel is removed.
Step 2. The back panel will not be used again in the see-through
application. Discard back panel and screws.
NOTE: When converting to the see-through fireplace the glass
windshield clips will need to be installed. See Figures 18 and 19
on Page 16. The clips will be packaged with the glass windshields.
The see-through fireplace requires windshields on both sides for
proper operation.
SEE-THROUGH FIREPLACE DIMENSIONS AND CLEARANCES
Continued
CAUTION
SHARP EDGES - WATCH YOUR FIN-
GERS
Wear gloves to guard against any
sharp metal edges.
BACK VIEW REAR PANEL INSTALLED
Side View Detail for Removal Rear Panel Screws
Nailing Flange
Bottom Fin
Valve
Box
Back
Wal
l
Nailing Flange
