INNOVATIVE
HEARTH PRODUCTS • KITS AND ACCESSORIES • BLOWER KIT (MODELS FBK-100 AND FBK-200)
5
NOTE: DIAGRAMS AND ILLUSTRATIONS NOT TO SCALE
Figure 11: Removing the Burner from Elite Linear Fireplaces
AUX OUT
FAN
POWER
Rotate burner to release air shutter
adjustment rod from air shutter lever.
Air Shutter
Adjustment Rod
Venturi
(attached to
burner orifice)
UNIVERSAL VENT-FREE FIREBOXES
•
Blower Kit FBK-100 or FBK-200
•
Junction Box Kit JBK
1.
Access the bottom compartment.
Models UVFRC-4228, UVFRC-4228-H, UVFRC-3628,
UVFRC-3628-H
Lift out the bottom firebox liner panel (
Figure 18
).
Figure 12: Removing the Bottom Firebox Liner Panel
Models
UVFRC-4228, UVFRC-4228-H,
UVFRC-3628 and UVFRC-3628-H
Bottom
Refractory
Panel
Model UVF-36
Using a screwdriver, remove the screw from the blower access
panel (
Figure 19
). Slide the panel to the right until the flange
clears the opening. Remove the panel and set aside.
Figure 13: Removing the Blower Access Panel
Firebox Floor
Remove Screw
Blower
Access
Panel
2.
Remove the rectangular junction box knock-out on the right
side of the unit. Install the junction box and electrical outlet
below the firebox floor into the rectangular opening on
the right side cabinet panel (with the removed knock-out)
(
Figure 20
and
Figure 21
). The junction box/electrical kit is
sold separately.
NOTE:
Pass the wires through the hole, then squeeze the
junction box flanges together to fit into opening.
Figure 14: Installing the Junction Box
Firebox
Floor
J-Box Flange
Install Into Side Wall Rectangular Opening
J-Box & Electrical Outlet
Figure 15: Wiring the Junction Box
J-Box And
Electrical Outlet
J-Box Flanges
Wires
Right Outside Cabinet Panel
3.
Loosely tie a knot in the power cord to take up slack
(
Figure 22
).
