NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
7
INNOVATIVE HEARTH PRODUCTS
•
LINEAR ELECTRIC FIREPLACE
•
INSTALLATION INSTRUCTIONS
The On/Off Switch is located on the right
side of the unit below the Heater Cutoff
Access Panel. In the recessed install
option, this switch must be turned into
the "ON" position and the appliance
must be controlled with the remote
provided.
Note: Ensure the circuit breakers for the power
supply are turned on.
This appliance can be activated using the fire-
place and heater On/Off Switch (see
Figures 7
& 8
)
or by using the remote control when the
unit power switch is already in the "ON" position.
The manual controls are located on the firebox
floor on the front left (see
Figure 5
)
. If an
optional glass enclosure is installed, it must
be removed to access.
MAINTENANCE
This appliance has been designed to provide
many years of trouble-free service. The com-
ponents that will need to be serviced have been
kept to a minimum. Periodic dusting of the
fireplace is all that should be required.
WARNING
An authorized service represen-
tative should perform any other
servicing.
CAUTION
Handle glass very carefully to
prevent accidental breakage.
CAUTION
Do not use abrasive cleaners on
the glass panel. Do not spray
liquids directly onto any surface
of the fireplace.
WARNING
When cleaning the fireplace, the
fireplace must be cool.
CLEANING THE GLASS ENCLOSURE
PANEL
Over time the front glass panel may become
dirty or dusty. Dust can be removed by lightly
rubbing the glass surface with a clean, lint free
cloth or paper towel. To remove fingerprints
or other marks, use a damp cloth with a good
quality household glass cleaner. The front glass
panel should be completely dried with a clean,
lint free cloth or paper towel.
CAUTION
Disconnect power before
attempting any maintenance or
cleaning to reduce the risk of
fire, electrical shock or personal
injury.
Figure 7
On
Fireplace and Heater On/Off
When the main power switch is turned on,
power is supplied to the fireplace.
Off
Figure 8
Main Power Switch in "OFF"
Position.
OPERATION
The appliance can be turned on either by the
switch located on the lower right hand side of
the heater body or by supplied remote control.
Manual Operation
1. The main power ON/OFF switch in position
“O,” the heater is OFF.
2. When main power ON/OFF switch is at posi-
tion “I,” the heater is ready to use.
3. Press the HEAT button on the remote control
repeatedly to set the heater to desired heat
setting.
4. Press the Flame brightness adjustment
button to adjust the flame height and ember bed
brightness. Press and release the FLAME control
button to cycle through LO, MED, HI and OFF.
SAFETY CUT-OFF
• This appliance is fitted with a safety
cut-off which will operate if the heater
overheats (eg. due to blocked air
vents). For safety reasons, the heater
will NOT automatically reset.
• To reset the appliance, disconnect
the appliance from the mains supply
for at least 30 minutes. Reconnect
the supply to the main switch on the
appliance.
AUTO MODE
Under this mode the heater will automatically
turn ON at high heat setting 1500w heat output
when the room temperature drops below 72˚F
(22˚ C). When the room temperature is between
72-77˚F (22-25˚ C) the heater output will switch
to low heat set ting 1000W. When the room
temperature goes above 77˚F (25˚ C) the heater
will be turned off and the cycle will continue.
900264-00 Rev. NC 06/14
