IHOS Dilos, User Manual

Page: 16 / 20

DILOS/DILOS SUB CONTROLS AND DUNCTIONS
PANEL FUNCTIONS INSTRUCTIONS
Link to power in of the next loudspeaker box, the
voltage is same between power out and power in.
Insert the power cord, rotate right to ON turn the
power on, reverse to OFF turn the power off.
Switch to ON to power on this loudspeaker
Power on the mains electricity: the applicable
voltage of the machine is 220-240V ~ 50 / 60Hz.
Please connect it with the power cord of the machine,
insert the power cord, turn right to on, turn left to
off.
This coding switch can set different address codes
for each array box, so that the software can distin-
guish each speaker for debugging. The specific coding
rules are based on "8421" coding, there are 32
different combinations, please see the software
interface settings for details.
When the machine is powered on and there is no power
on signal, the light will not be on. When there is an
input signal, the light will be green. When the
machine reaches full power, the light will be red.
When the machine is powered on, the indicator light
is blue, indicating that the power supply of the
machine is normal.
Only for controlling the gain of the product, turn it
to the right and gradually increase the volume
This port is the RS485 control output port, which can
be connected with the network cable input port of the
next D8F/SUB through the network cable (the network
daisy-chaining structure, up to 32 speakers can be
debugged simultaneously.
This port is the RS485 control input port, which can
be connected with the control signal distributor
through the network cable (the network cable level
adaptor and XLR audio interface to connect, by using
software to control every single loudspeaker box with
regard to gain, EQ, noise gate, compression, polari-
ty, delay, etc. Please refer to the software settings
for details.
It can be connected to LINE signal source (such as
The output signal can be connected to the signal
input interface of the next D8F/SUB through XLR line,
and the output signal is the same as the input
signal.
.