5
SETTING THE TIME:
TIME SYNC & MANUAL TIME SETTING
DST SWITCH
This unit has a Daylight Saving Time (DST) Switch on the bottom of the unit. By
default, the switch is set to Auto and will automatically adjust the time at the
start and end of Daylight Saving Time. To adjust this manually, move the switch
to -1 to subtract an hour or to +1 to add an hour.
TIME SYNC
This unit is equipped with auto sync. By default, the unit will sync to the time on
your iPhone or iPod whenever you dock it in the Lightning dock. When successful,
the updated time will appear on the display. While the dock accommodates most
cases, you may need to remove your case for proper docking. To manually sync
at any time, press and release the
Time Sync Button
. If sync is unsuccessful, try to
sync again using a different iPhone or iPod. If sync still doesn’t work, set the time
manually (see
below).
Setting the time manually
1.
Press and hold the
Time Sync/Time Set Button
until “AUTOSYNC ON” flashes
in the display and a beep sounds. Press the
+
or
–
Buttons
so “AUTOSYNC
OFF” appears in the display, indicating manual time setting mode.
2.
Press and release the
Time Sync Button
. “CLOCK SET” will appear on the
display and the time will flash. Press the
+
or
–
Buttons
to set the correct time
(hold for rapid adjustment). Make sure to set the correct AM or PM time. (The
PM/AM indicators appear to the left of the time display.)
NOTE
: The display can be set to standard 12 hour time (AM and PM) or to 24
hour time. To toggle between 12 and 24 modes, press and release the
Alarm 1
or
Alarm 2 Button
located on top of the unit at any time while display
is flashing during manual time setting mode.
(Continued on page 6)
