5
Using the Optional Remote Control
The remote control battery is already installed at the factory. When the remote control stops operating or its range seems
reduced, it is time to replace the battery with a new one.
1. The battery compartment is located on the back end of the unit.
2. Slide the battery compartment door to release the battery door.
3. Remove the old battery and insert a CR2032 battery, checking that the + and – sides of
the battery match the drawing on the battery door.
4. Replace the battery door on the remote control.
Note:
Make sure you dispose of batteries properly (see your local regulations).
Battery Compartment
iR70
Pressing the 3D button will toggle the 3D effect on and off.
Power Button turns unit ON and OFF
Remote not included
with all iP71
models.
To order a remote,
please visit
www.ihomeaudio.com
Volume Buttons raise and lower volume on the unit.
Install/Replace the Remote Control Battery
Pressing and holding FWD/REV while iPhone/ iPod is docked will scan forward/reverse
within currently playing track.
Pressing Play/Pause while iPhone/iPod is docked and plaing will pause iPhone/iPod.
Press again to resume play.
Pressing FWD/REV while iPhone/iPod is inserted will FWD/REV to next/previous track
Pressing Play/Pause from power off mode will play iPhone/iPod.
The up, down, fwd, rev, menu and enter buttons are used to navigate the iPhone/iPod.
The shuffle and repeat buttons will activate/deactivate the iPhone/iPod’s shuffle and
repeat modes.
Pressing the up/down buttons for Bass and Treble, will raise or lower bass or treble
Pressing the reset button will reset Bass and Treble level to 0 and turn 3D effect off.
Pressing the mute button will mute unit. while unit is muted, LED will flash as long
as unit is muted. Pressing mute again or pressing volume up or down will unmute.
