Replacing Clock Backup Batteries
Battery Warning
10
P13
Dimmer Operation
During normal operation, press the
Snooze Button
to control the brightness of the LCD display.
The iA100 comes with 2 x AA backup batteries installed to provide backup alarm
operation and clock settings in the event of a power failure. When the battery low
indicator appears on the diisplay, it’s time to replace the batteries.When the
Backup Batteries have been installed and a power failure occurs or the AC cord
is accidentally disconnected, the display backlight will not remain lit, but current
time and alarm time settings will be temporarily maintained. Otherwise, you must
reset the time and alarm settings.
1. Open backup battery compartment door located on the bottom of the unit.
2. Please make sure the AC adaptor is connected. Otherwise all settings may be
lost during battery replacement.
3. Insert 2 AA batteries, checking that the polarity (+ and – ends of the battery)
matches the drawing near the battery compartment. Close the compartment
door.
Note:
Make sure you dispose of batteries properly (see your local regulations).
Replacing Backup Batteries
���
���
���
For models that require more than one battery
• Do not mix with used or other battery types/brands
• Replace all batteries at the same time
• Do not open batteries
• Do not dispose of in fire
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
The batteries (battery pack & batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.
The mains plug is used as disconnect device and it shall remain readily operable during intended use. In order to
disconnect the mains plug from the mains completely, the
mains plug should be disconnected from the mains socket outlet completely.
Do not place any naked flame sources, such as lighted candles, on the apparatus.
When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of
these batteries must be followed strictly.
• Do not heat above 75ºC (167ºF)
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
