Listening to non-docking iPod or other portable audio devices
If you are using an iPod without a docking port or other MP3 player or other portable audio device, you can
still play it through the iH30 via the Line-in Jack.
1. Plug one end of the audio patch cord (included) into the headphone or line-out jack on your device and the
other end of the patch cord into the iH30
Line-in Jack
, located on the front of the unit.
2. Press
Power On/Off Button
on main unit or remote to turn iH30 on.
3. Press the
Mode Button
until you can see “AU” showing on the display, indicating AUX playing mode.
4. Press the
and
Volume– Button
on main unit or remote control to adjust the system
volume. You may need to adjust your device volume too.
5. To turn off the unit, press the
Power On/Off Button
on main unit or remote control to turn it off. Please
remember to turn off your device, too.
Listening to FM Radio
Note: Extend FM rod antenna fully for best reception. In some areas, it may be difficult to get stereo sound
without interference. If this proves a problem, set the
Mono/Stereo FM
switch on the back of the unit to
Mono.
1. Press the
Power On/Off Button
on the iH30 or remote to turn unit on.
2. Press the
Mode Button
on the iH30 or remote control until you can see a radio frequency showing on
the display.
3. Use
Tune Up
or
Tune Down Button
to tune in to the desired station.
4. Press and hold the
Tune Up
or
Tune Down Button
for appox. 2 seconds, it will start to auto seek
available stations and will stop when a clear one is found.
5. Press the
and
Volume– Button
on the iH30 or remote control to adjust the iH30 volume.
Press the
Mute Button
to mute the output; press the button again to release it.
6. To turn off the unit, press the
Power On/Off Button
on the iH30 or the remote control to turn it off.
12
Summary of Contents for 2go iH30
Page 2: ...Model iH30 the portable system for your iPod TM ...
Page 3: ...iH30 ...
