background image

I

C Statement: 

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to 

the following two conditions: (1) this device may not cause interference, and (2) this device must 

accept any interference, including interference that may cause undesired operation of the device. 

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. 

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) 

l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en 

compromettre le fonctionnement.

 

 

 

This device and it's antennas(s) must not be co-located or operating in conjunction with any other 

antenna or transmitter except in accordance with IC multi-transmitter product procedures. 

Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou 

transmetteur. 

 

 

This radio transmitter (IC: 3857A-ML6035G3) has been approved by Industry Canada to operate with 

the antenna types listed below with the maximum permissible gain indicated. Antenna types not 

included in this list, having a gain greater than the maximum gain indicated for that type, are strictly 

prohibited for use with this device.   

Le présent émetteur radio (IC: 3857A-ML6035G3) a été approuvé par Industrie Canada pour fonctionner avec les types 

d'antenne énumérés ci-dessous et ayant un gain admissible maximal d'antenne. Les types d'antenne non inclus dans cette 

liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.

 

 

Antenna list: 

Gain (dBi) 

Ant. 

Brand 

P/N 

Antenna Type 

Connector 

Band 1 

Band 4 

Remark 

1 Accton 

123400001084A  Dish 

Ant. 

N/A 

15.7  18.1 Internal 

Ant. 

Brand 

P/N 

Antenna Type 

Connector 

Gain (dBi) 

Remark 

2 Accton 

FD5-14 

Dish 

Ant.  Dual 

RPSMA 

pigtails 

14 

External 

  Note: Ant. 1 & Ant. 2 are the same type antennas, only the higher gain antenna “Ant. 1” was tested. 

Summary of Contents for ML-60-19











Reviews: