20
WARNING
GENERAL HAZARD
Failure to follow instructions can cause serious
injury or death.
Before you leave the operator’s seat:
•
Lower the lift arms and put the attachment /
implement flat on the ground.
•
Engage the parking brake.
•
Move all controls to the NEUTRAL / LOCKED
position to make sure the lift, tilt, and drive
functions are deactivated.
•
Stop the engine.
◂
W-3156
13. Connect auxiliary hydraulic hoses (if applicable).
(See Hydraulic Quick Couplers on Page 21)
Connecting The Hydraulic Hoses For The First Time
For first time use of the auger, use low engine rpm and
feather the auxiliary hydraulics to fill the internal
passages of the auger drive with hydraulic oil. If the auger
is used without first filling the hydraulic passages, internal
damage may result.
New attachments are factory equipped with flush face
couplers. If installing an attachment equipped with poppet
style couplers, the attachment couplers will have to be
changed to match the loader. Contact your Ignite
Attachments representative for parts information.
IMPORTANT
MACHINE DAMAGE HAZARD
Failure to follow directions may result in machine
damage.
Thoroughly clean the quick couplers before making
connections. Dirt can quickly damage the system.
Contain and dispose of any oil leakage in an
environmentally safe manner.
◂
I-2278
1.
With the loader engine off and using the hose guides
(if equipped), route the attachment hydraulic hoses
to the loader.
2.
Connect the attachment hydraulic quick couplers to
the loader’s couplers.
(See Hydraulic Quick Couplers on Page 21)
3.
Check that the attachment hydraulic hoses are not
twisted or contacting any moving parts of the
machine or attachment.
NOTE:
It may be necessary to loosen the quick
couplers on the attachment hydraulic hoses
to remove any twists in the hose.
WARNING
IMPACT AND INJECTION HAZARDS
Flying debris or pressurized fluids can cause
serious injury or death.
Wear safety glasses to prevent eye injury when
any of the following conditions exist:
•
When fluids are under pressure.
•
Flying debris or loose material.
•
Engine is running.
•
Tools are being used.
◂
W-2019
4.
Loosen the quick coupler connections on the
attachment hydraulic hoses while connected to the
machine. Do not remove the quick couplers.
5.
Rotate the attachment hydraulic hoses as needed so
the hoses are not twisted or contacting any moving
parts of the machine or attachment.
6.
With the twist(s) removed from the hydraulic hoses,
tighten the attachment quick coupler connections
while the couplers are still connected to the machine.
This will help hold the hydraulic hoses in position
while tightening.
7.
Before starting the machine, tighten the quick
couplers connection specific to your loader
attachment.
8.
Enter the loader.
(See Entering And Exiting The Machine on Page 16)
9.
Start the engine.
10. Engage auxiliary hydraulics. (See the loader’s
Operation & Maintenance Manual for correct
procedure).
WARNING
INJECTION HAZARD
Pressurized diesel fuel or hydraulic fluid can
penetrate skin and eyes, causing serious injury
or death.
Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks.
DO NOT use your bare hand. Wear safety
goggles. If fluid enters skin or eyes, get
immediate medical attention from a doctor
familiar with this injury.
◂
W-2072
11. Check the attachment hydraulic quick coupler
connections for leaks.
Summary of Contents for Auger 75 DDH
