-11-
www.igmtools.com
Step 42. Take the plastic bolt end caps to cover all the bolt ends on the
inside of the Octagon drum base using (22) plastic end caps. This step is
necessary to prevent any injuries caused by the sharp end of the bolts.
Step 43. Once completing the assembly, keep the drum laying on its
side to apply silicone (not included) to the inside of the drum, including
the base and the top rim of the drum before the rubber seal has been
attached to seal and prevent air leakages. You will need to use a caulking
gun (not supplied)
Step 44. Attach the rubber gasket to the top inner edges of the Octagon
drum. The wider end of the gasket goes up. Use tin snips to trim any
excess rubber gasket after completing the seal.
Step 45. Insert the plastic debris collection bag inside the Octagon drum.
Open and spread out the plastic bag to the corners and edges.
Step 46. Use (24) Round hd Philip bolts 3/16”*1/2” and (24) Cap nut 3/16”
to assemble the drum insert together. Place the drum insert inside over
the plastic bag in the Octagon drum.
Step 47. Lift the foot peddle bar. Align the Octagon drum window to the
center point of the drum lid and push the drum in. Lower the foot peddle
bar to seal the drum tight for normal machine operation.
Step 48. Make sure when aligning the drum that both the left and right
side lift plates are over the topping on the foot peddle bar assembly before
lifting the foot peddle bar up. When not aligned, the drum will not be fully
sealed and will interfere with the air flow.
Step 49. Using the white plastic pin, insert the sharp point into the top end
of the proximity sensor that is on top of the drum lid. You will find a small
hole to on top where you can turn clockwise or anti-clockwise.
• Clockwise: Lower dust waste level in drum (Less full drum)
• Anti-clockwise: Higher dust waste level in drum (Fuller drum)
Step 50. Install the intake splitter. For the PFLUX3 install the 8” by 4” x 3
ports to the intake using (3) M4 x 12mm sheet metal screws. Attach the
rubber caps to each 4” port.