-7-
www.igmtools.com
Step 5: Attach the intake cylinder to the dust chute using hex
spring bolts (4) 8 mm*16 mm. Then, attach the cyclone barrel onto the
dust chute using hex bolts (12) 8 mm*19 mm and flat washers (12) 8
mm*OD18*2T. Followed by attaching the cyclone funnel to the barrel using
hex bolts (12) 8 mm*19 mm, flat washers (24) 8 mm*OD18*2T and hex
nuts (12) 8 mm.
Step 6: Secure the base with (3) lower upright support panels to the unit
using hex bolts (6) 8 mm*19 mm and flat washers (6) 8 mm*OD18*2T.
Step 7: Secure the 3 (T) upright support reinforcement plates using hex
bolts (12) 8 mm*19 mm and flat washers (12) 8 mm*OD18*2T.
Step 8: With the help of another person, lift the unit up carefully to the
right side up with the motor on top and the wheels at the bottom.
Step 9: Secure the lower triangular support plate to the base using (4) hex
bolts 8 mm*19 mm and flat washers (4) 8 mm*OD18*2T. Follow the same
steps for the opposite side.
Step 10: Slide the Foot pedal bar into the opening on the lower upright
support panel (R). Make sure the end of the bar is on the inside of the
triangular support plate. Follow the same steps for the opposite side.
Step 11: Secure the foot pedal support to the lower upright support panel
using carriage bolts (4) 8 mm*13 mm, flat washers (4) 8 mm*OD18*2T
and hex nuts (4) 8 mm. Then secure the foot pedal bar to this support
using hex bolts (4) 8 mm*44 mm, flat washers (8) 8 mm*OD18*2T and
hex nuts (4) 8 mm. Same for the opposite side.
3HP Mobile Dust Cyclone Manual
17
Step Six: Secure the base with (3) lower upright support panels to the unit
using (6) 5/16”*3/4” hex bolts and (6) 5/16”*OD18*2t flat washers.
Step Seven: Secure the (3) upright support reinforcement plates (T) using (12)
5/16”*3/4” hex bolts and (12) 5/16”*OD18*2t flat washers.
3HP Mobile Dust Cyclone Manual
18
Step Eight: With the help of another person, lift the unit up carefully to the
right side up with the motor on top and the wheels at the bottom.
Step Nine: Secure the lower triangular support plate to the base using
(4)
5/16”*3/4” hex bolts and (4) 5/16”*OD18*2t flat washers
..
Follow the same steps
for the opposite side.
19