-10-
www.igmtools.com
Step 29: Lift the foot peddle bar. Align the Octagon drum window to the
center point of the drum lid and push the drum in. Lower the foot peddle
bar (s) to seal the drum tight for normal machine operation.
Step 30: Make sure when aligning the drum that both the left and right
side lift plates are over the topping on the foot peddle bar assembly before
lifting the foot peddle bar up. When not aligned, the drum will not be fully
sealed and will interfere with the air flow.
Step 31: Take the switch box, open it by removing the bolt at the bottom of
the switch box to mount to the switch base plate using (4) M4 x 6mm flat
head bolts.
Step 32: Install the Remote Switch Box to the switch plate on the motor
using hex bolts (4) 6 mm*19 mm and flat washers (4) 6 mm*OD19*2T.
Step 33: Take the paddle and paddle branch and assemble together
using hex bolts (4) 6 mm*16 mm, flat washers (4) 6 mm*OD19*1T and
nuts (4) 6 mm.
Step 34: Assemble the two paddle and paddle branch assemblies to the
rotation shaft using hex bolts (4) 6 mm*16 mm, flat washers (4) 6
mm*OD19*1T and nuts (4) 6 mm.
Step 35: Insert the rotation shaft assembly into the canister filter. Slightly
bend the paddles to get them into the canister filter.
Step 36: Assemble the canister filter to the dust chute. Tighten the band
clamp and adjust the tightness accordingly to ensure the canister filter is
tightly fitted onto the dust chute.
Step 37: Attach the canister cover plate to the dust chute using (12) 5
mm*13 sheet metal thread bolts.
3HP Mobile Dust Cyclone Manual
30
Step Thirty Two: Install the Remote Switch Box to the switch plate on the motor
using (4) 1/4”*3/4” hex bolts and (4) 1/4”*OD19*2t flat washers.
Step Thirty Three: Take the paddle and paddle branch and assemble together
using (4) 1/4”*5/8” hex bolts, (8) 1/4”*OD13*1t flat washers and (4) 1/4” hex nuts.
Step Thirty Four: Assemble the two paddle and paddle branch assemblies to the
rotation shaft using (4) 1/4”*5/8” hex bolts, (8) 1/4”*OD13*1t flat washers and (4)
1/4” hex nuts.
3HP Mobile Dust Cyclone Manual
30
Step Thirty Two: Install the Remote Switch Box to the switch plate on the motor
using (4) 1/4”*3/4” hex bolts and (4) 1/4”*OD19*2t flat washers.
Step Thirty Three: Take the paddle and paddle branch and assemble together
using (4) 1/4”*5/8” hex bolts, (8) 1/4”*OD13*1t flat washers and (4) 1/4” hex nuts.
Step Thirty Four: Assemble the two paddle and paddle branch assemblies to the
rotation shaft using (4) 1/4”*5/8” hex bolts, (8) 1/4”*OD13*1t flat washers and (4)
1/4” hex nuts.
3HP Mobile Dust Cyclone Manual
31
Step Thirty Five: Insert the rotation shaft assembly into the canister filter. Slightly
bend the paddles to get them into the canister filter.
Step Thirty Six: Assemble the canister filter to the dust chute. Tighten the band
clamp and adjust the tightness accordingly to ensure the canister filter is tightly
fitted onto the dust chute.
