11
TEMPERATURES SETTINGS
In the main window you can set the desired room air and hot water temperatures
(Window 5)
. This is carried out at follows:
by clicking on one of the symbols, the settings of which you want to change (the
activated function turns blue);
use +/- buttons to increase or decrease the indoor air or hot water temperature;
the numbers above indicate the current temperature and the numbers below
indicate the set temperature (set for the system);
the settings can be
“
locked” by clicking on the symbol again.
SYSTEM ERROR AND FAILURE INDICATIONS
If the symbol in the right corner of the main window is flashing or
–
the
system indicates a system error or fault. In the event of a system fault (bright triangle),
the heat pump will continue to operate, but every effort should be made to rectify the
fault.
In the event of a system fault (dark triangle), the heat pump operation will stop.
By clicking on the flashing symbol you will be redirected to the
Active Messages
window
(Window 6)
, where you will see a list of system errors and faults. The full list of
the meanings of these messages and possible causes is provided below, as well as
instructions on the actions the user should take.
When a non-critical issue is resolved, the error message disappears
automatically (without confirmation). After of elimination of other errors or a system
failure, they can be confirmed from the
app by pressing button ”Reset” (
Window 6) or
local control panel. See, section Control Panel on page 17. The fault is confirmed by
pressing the button ”Reset” on the control
panel for >4 seconds (Window 2)
Window 5
Window 6
