en
12
User manual Jamajka G
www.igloo.pl
Fig.5 Emptying the
reservoir
1 – Ball valve
2 – Over
fl
ow
Fig.6 Water in-
fl
ow reservoir
1 – Lifted water in-
fl
ow reservoir
Fig.7 Water reservoir
1 /2 /3 – Water level probes
4 – Over
fl
ow connection
5 – Water out
fl
ow
System is equipped with over-
fl
ow connection Fig.7/4 (p.12),
which is to drain water excess
when the reservoir is
fi
lled with
excessive amount of water.
4.2. Humidifying system
The device may operate both with moistening as well as without moistening. In case of “Jamajka G” device there
is no possibility to regulate humidity in detail – humidifying is realised by lifting water particles from the special
reservoir by hot air.
Filling / (emptying) the reservoir with water may be performed at any time, both when the device is in idle mode as well
as when it is working. However, please remember to check whether the water out
fl
ow ball valve is closed before pouring
more water Fig.2/10 (p.9).
Signalling control diodes inform about proper water level in the reservoir Fig.4/3; 4 (p.11).
Red diode signal signi
fi
es lack
of water or low water level (this is not an alarm signal!). If the device operates without humidifying the red diode
shall be illuminated all the time. When the device operates with humidifying the green diode informing about the
proper water level should be illuminated
. Change of lighting signals to red means that the water level is low and more
water should be poured into the reservoir.
4.3. Lamp set
Lamps are equipped with special bulbs aimed to work in high temperatures.
Type of utilized bulb: 40W (E27; bulb shape P45; max working temperature – up to 300ºC.
The lighting is turned on/off by the switch on control panel Fig.4/2 (p.11)
1
2
1
1
2
3
5
4
