en
18
User manual INNOVA
www.igloo.pl
Fig.5 Cleaning the condenser
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
Elements of device can corrode when improper used and maintenance. To avoid that please
follow the rules:
• Do not allow contact of the surface of the device with substances containing chlorine and / or baking
soda in different varieties, which destroy the protective layer and components of the device (also
includes various stainless steel)
During maintenance services it is necessary to pay attention not to damage the data place of the
device Fig.13 (p.10), which contains significant information for servicing organs and waste removal
companies.
The device uses a retractable front panel system with an electromagnetic lock blocking the slide.
To slide the glass out, switch on the open/close lock button on the control panel at the back of
the unit, and then press the release lock, while slightly pressing against the wooden casing for
the lock to let go. To draw the front glass back in, lightly press near the lock for the lock button to
switch on. To completely prevent from opening the front glass by unauthorized persons, turn off
the power of the electromagnet on the operating panel.
While drawing the glass front back in, press against it slightly where the lock is, and not in the upper part!
It is recommended to make a break in the exploitation of the device
once a month
in order to clean its interior,
naturally defrost the evaporator and clean the condenser.
It is essential to keep the
condenser of the device
clean. Dirt may hinder the heat exchange, causing mainly increase in electric
energy consumption and may cause damage of aggregate compressor.
In order to clean the condenser it is necessary to unscrew the sheet metal screws and pull the wind brace out of catch by lifting it
up. Clean condenser lamellas with help of soft brush or paint brush. If the condenser is extremely dirty (blocking of lamellas) it is
indicated to use vacuum cleaner or compressed nitrogen to suck / blow the dirt from between lamellas.
