en
12
User manual Costa
www.igloo.pl
3. PREPARING THE DEVICE FOR EXPLOITATION
3.1. Requirements concerning the place of installation
• Verify whether the cross-section of feeding conduits is proper for the power consumption of the installed device
• It is forbidden to connect the device by means of extension cords or dividers
• The device should be connected to the separate, properly made electric circuit with plug-in socket
with protecting pin (according to PBUE /Regulations concerning Electric Equipment Construction/)
The device may be actuated solely after con
fi
rmation of the
fi
re protection ef
fi
ciency with results of
measures performed according to binding regulations!
3.2. Connection and actuation
• Unpack the device and remove the wooden platform from the basis Fig.2 (p.12)
• Place the display cabinet on an even basis, which is hard enough, and then level it with feet.
• Remove the protecting foil from elements of the device (f. ex.: from the inside of the device and the front fender beam)
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following operations:
1. Mount the hook system on rack frames Fig. 3 (p.12)
2. Defrosted water outlet is located under the body of the device (about 110 mm from the back of the rack, in the middle part
of the body), and water outlet should be connected with sewage grid.
• Place the plug of the connecting cable directly in plug-in socket (it is forbidden to connect the device by means
of extension cords or dividers!)
• Turn the main switch on Fig. 8/2 (p.13), which will activate the thermostat, and then the aggregate of the device.
• Set the temperature on the thermostat panel Fig.8/1 (p.13) (service details on p.17 or 18)
• Turn on the lighting switch Fig. 8/3 (p.13)
Fig.3 Mounting the hook
in the rack frame
Fig.4 Grid shelf system
Fig.2 Removing the wooden platform
1 – Screen of the rack
2 – Frame for mounting the hooks
3 – Hook (adjusted to three-degree regula-
tion of the suspension angle)
1 – Grid shelf
2 - Hook system with pro
fi
les (shelf
tightening construction)
1 - Unscrew the feet from the platform
2 – Remove the wooden platform
3 – Screw the feet in nuts welded to the
frame of the device
1
2
3
1
2
3
1
2
• The
fi
rst cleaning of the device should be provide right after unpacking, and before turning it on. The unit should
be cleaned with water at a temperature not exceeding 40°C with a neutral detergent. For washing and cleaning
the equipment it is prohibited to use products containing chlorine and sodium varieties, which destroy the protecti-
ve layer and components of the device! Any residue of adhesives or silicone on metal elements should be remo-
ved only with extraction naphtha (not applicable to items made of plastic !). Do not use other organic solvents.
When cleaning the unit is prohibited to use water jet. The unit should be cleaned with a wet rag.
