IGF VULCAN BRACE Series, Manual For Use And Maintenance

Page: 19 / 32

page 19
Therefore, after the burner is switched on (see Instructions for use paragraph
2), it is necessary to keep pressing the knob for about 6 (six) seconds, in or-
der to let the gas in and allow the safety thermocouple to warm up.
4) How to use the lava rock grill
In order to achieve good results without causing any damage to the lava rock
grill, it is necessary to switch on the necessary burners following the Instruc-
tions for Use, paragraphs 1, 2 and 3. Once the burners are switched on, bring
the knob to the position of maximum power, marked by the symbol 1 (one)
and keep it in that position for not more than 6 (six) minutes.
Then bring the knob to the position of minimum power marked by the symbol
½ (a half) and keep it in that position for other 6 (six) minutes.
At this point the right temperature has been reached and it is possible to start
the cooking.
During cooking, the knob must always rest in the position of minimum power
marked by the symbol
½ (a half).
At the end of cooking, bring the knob back to the “off” position marked by the
symbol
0 (zero) and always remember to close the gas tap or the cylinder tap.
INSTALLATION AND OPERATION
The installation must be performed by qualified technicians and al-
ways in compliance with the manufacturer’s instructions. A wrong
installation may cause damage to people, animals and things. The
non compliance with the installation procedure may lead to damage to the
Equipment. The manufacturer disclaims responsibility for any damage caused
to the Equipment or to people, animals and thing due to an installation proce-
dure which was not carried out in accordance with the manufacturer’s instruc-
tions. It is strictly forbidden to use the machine to perform different functions
from those described in the manual and to introduce any change to the ma-
chine without the approval of the manufacturer.
1) After the lava rock grill has been assembled and before its installation, ensure
that the type of gas supply corresponds to the type indicated in the identifica-
tion plate, placed in the machine.
2) If the machine is supplied by Methane, connect the lava rock grill to the gas
supply by means of a copper pipe or a flexible steel pipe, with an internal di-
ameter of not less than 14 mm.
Ensure that the connecting pipe is approved.
3) If the gas supplied, either by a gas main or by a gas cylinder, is L.P.G it is
necessary to install a pressure reducer by the outlet of the gas supply, so that
the gas outlet pressure corresponds to the pressure of the methane supply
system of the Country where the Machine is installed.
Connect the lava rock grill to the gas supply by means of a copper pipe or a
flexible steel pipe, with an internal diameter of not less than 14 mm.
Â
Â