4
Using your Fan Heater
•
Turn the thermostat dial (right) in a clockwise direction until it reaches the maximum setting.
•
To use the fan only (no heat), turn the selector switch (left) to the
setting.
•
To use the heater on the lower heat setting, turn the selector switch (left) to setting
•
To use the heater on the high heat setting, turn the switch (left) to setting
•
To switch off the heater, turn the switch (left) to the 0 setting.
Using the Thermostat
When the room has reached the required temperature turn the left thermostat dial slowly in an anti-clockwise
direction until the heater switches off and a small “click” will be heard from the thermostat. The heater will now
keep this temperature and will switch on and off to maintain the temperature in the area the fan heater is located.
Cleaning and Care
•
Before cleaning the heater, ensure it is disconnected from the power supply and has cooled down
completely.
•
Do not use abrasives or harsh cleaning solutions.
•
Do not immerse the heater in any liquid. To clean the exterior, use a slightly damp lint free cloth.
•
Clean the air inlet / outlet grilles frequently.
Safety Cutout
The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (e.g.
obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, disconnect the plug from the
power for a few minutes, remove the cause of the overheating then plug the appliance in again. If it still cannot be
reset, ask a qualified technician to check and/or repair.
Warnings
•
Do not use the appliance in the vicinity of showers, bath tubs, wash basins, swimming pools, etc.
•
Always use the heater in an upright position.
•
Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of
overheating).
•
The heater must be positioned at least 1 meter from furniture or other objects.
•
Do not place the heater up against walls, furniture, curtains, etc.
Troubleshooting
Problem
Possible Cause
Solution
The heater does not work.
1. Not properly plugged into the
mains wall socket.
2. No electricity in the mains
wall socket.
3. On/Off switch not turned on.
4. Safety cut-out activated.
5. Thermostat is set too low.
1. Plug in firmly
Check fuse or breaker.
2. Push on/off switch to on.
3. Unplug the heater from the
mains, remove cause of
overheating and allow to cool
for a few minutes.
4. Turn up the thermostat until
the heater starts to work.
The heater is not blowing out
hot air.
1. Fan only is selected.
1. Turn the selector switch to
setting I or II
View the range online at www.igenix.co.uk
Follow us on Twitter
@Igenix_Products
