4
APPLIANCE OVERVIEW
Lid
Spout
Kettle
LED indicator
On button
Off button
Handle
Water level indicator
Figure 1
OPERATING INSTRUCTIONS
1. Before use always ensure the voltage is set to
match the mains voltage (110V or 220V).
Voltage switch is located near the base of the appliance.
Fig.1: 110V
Fig. 2: 220V
2. Fill the kettle with water. Fig 3.
3. Do not fill the appliance beyond the
“MAX” indicator. Insert Fig 4
4. Close the lid and make sure the lid is properly closed,
otherwise the appliance will boil dry.
5. Plug into the mains electricity supply and press
the “On” button. Fig 5.
6. When the kettle is on, the neon will light up.
7. The appliance will automatically switch off when
the water reaches boiling point.
8. To stop it manually; press the” Off” button. Fig 6.
9. This appliance is designed with overheat protection. If the kettle has just been switched off, wait for
a few minutes to reset the thermostat before switching it back on again.
10. If there is no enough water in the kettle, or the kettle is switched on when it is empty, the safety
cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for
the element to cool, then use as normal.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
