4
Safety Cut Out
The appliance features a safety cut out switch, this will protect the element if the water level becomes
too low.
• To reset the safety cut out, switch off the appliance and unplug from the electricity supply and allow
the appliance to cool down.
• Once cold, empty the water out and press the reset button located on the bottom of the appliance.
• Refill with cold water and plug into the electricity supply, the appliance is now ready to be switched
back on again.
CLEANING AND MAINTENANCE
Descaling
If allowed to build-up, limescale can cause the element to overheat and can cause the tap to stop working
correctly. Regular checks need to be made of the inside of the appliance for signs of limescale. It is
important that limescale deposits are removed by using descaling tablets, powders or liquids. If you are in
a hard water area, the appliance may need to be descaled every week. If you are in a soft water area then
descaling the appliance will not need to be carried out so often.
Exterior
Use a clean, damp soft cloth to wipe the exterior surface of the appliance and dry thoroughly.
Important: Do not use abrasive cloths, powders, household cleaners, bleach or wax polish to clean the
appliance as these can leave a smell in the appliance and can damage the exterior.
Fuse Replacement (Class I)
This appliance must be earthed. There are 3 screws on the plug, remove them
and open the shell. Take out fuse and replace with a new fuse of the same Amp.
Install the shell again and tighten the screws.
MAINS PLUG FUSE REPLACEMENT
5. Plug the appliance into the electrical supply and switch the appliance on by pushing the ON/OFF
button, the red indicator light will illuminate and the appliance will begin to heat the water. Once
water has reached the preset temperature, the red indicator will go off and the orange indicator will
illuminate to indicate that the appliance will go into keep warm function.
6. When the keep warm function is on the indicator will be on.
7. Use the thermostat dial to set the temperature you would like to maintain the water at.
8. Use the tap to dispense water.
9. When finished empty water, switch appliance off and disconnect from the electricity supply.
