iGenix IG3751, User Manual

Page: 7 / 16

7
OPERATING INSTRUCTIONS
Before using your Freezer
Before placing food in the freezer, it needs to be cleaned by wiping the interior using warm water and a
soft cloth. Wipe the freezer completely dry before replacing the shelf.
Check that your power outlet is compatible with the plug supplied with the freezer.
IMPORTANT: Always allow at least 2 hours before turning on the freezer to allow the coolant fluid
time to settle after the freezer is in place. Failure to do this may result in damage to the appliance and
such damage is not covered by the guarantee.
Door Fitting
The freezer door can be fitted to open to either the left or the right depending on its location. The
appliance must be tilted and supported in order to carry this out. It is therefore advisable to get some
help during this procedure. Take care when fitting and tightening screws.
To change the direction, please follow these instructions.
• Turn off the power.
• Remove the top hinge cover (6), hinge screws (1) and hinge (5) (right side).
• Lift the door and place on a padded surface to prevent scratching it.
• Remove the two screws (8) that hold the lower hinge (2) and mare sure to remove the
lower hinge (2)
• Remove the left front leg (4) and transfer it to the right side
• Remove the hole cover plate (7) to the right side
• Before placing this lower hinge (2), remove the bolt pin (9) and reverse the direction of the lower
hinge (2). Then install the lower hinge (2) onto the left side f the lower frame with 2 screws (8)
• Insert the bolt pin (9) to the lower hinge (20
• Set the door to its place making sure the door sits on the lower hinge (2)
• While holding the door in the closed position secure the upper hinge (5) in the top frame of left
side with two screws (1)
• Please remember to not tighten the two screws (1) until the top of the door is levelled with
the counter top.
• Install the upper hinge cover (6) on the upper hinge