5
•
Wait a few seconds before pressing the steam button (2) again if there are more creases that need
to be removed.
DRY IRONING
•
Plug the iron into a suitable power socket.
•
Ensure the steam control (7) is turned to the Dry Ironing position.
•
Select the setting on the on the Temperature Control (1).
•
When the pilot light goes out the iron is ready for use.
•
When you have finished ironing disconnect the iron from the mains supply and allow to cool
completely before storing away.
STORAGE
•
Turn the Temperature Control dial (1) to the ‘OFF’ position and the Steam Control dial (7) to the ‘O’
position.
•
Disconnect from the plug from the power socket.
•
Pour any remaining water out of the water tank.
•
Stand the iron in the upright position and let it cool down completely.
•
Always store the iron in an upright position.
CARE AND CLEANING
•
Turn the Temperature Control dial (1) to ‘OFF’ and disconnect the iron from the power socket and
allow it to cool down completely.
•
The casing can be wiped with a damp cloth and polished with a dry cloth.
•
Remove dirt spots from the soleplate by using a small amount of vinegar a cloth. Be sure not to
scratch the soleplate.
•
Never use abrasives to clean the soleplate.
•
Keep the soleplate smooth, avoid contact with metal objects.
SAFETY PROTECTIVE CUT-OUT
In the unlikely event of the thermostat failing, the protection cut-out will operate to prevent the iron
overheating.
Troubleshooting
If you are having problems with your iron, please use our troubleshooting guide below. If you are unable
to resolve the issue using the guide please ring our Customer Service Department on
01473 271 272. Please have the model code, batch number and purchase information available.
Problem
Possible Cause
Solution
The iron does not work.
1. Not properly plugged into the
mains wall socket.
2. No electricity in the mains wall
socket.
1. Plug in firmly.
2. Check fuse or breaker.
The iron leaks and there is not
much steam produced.
1. The thermostat is set too low.
2. The water tank is too full.
3. The water in your area is hard
and has caused a mineral
deposit build up in the iron.
1. Turn the thermostat to a higher
setting.
2. Empty some water out of the
water tank.
3. Follow the ‘Care and Cleaning’
section to remove deposits and
consider using de-mineralized
water.
The iron does not remove creases.
1. Temperature is set too low for
the type of fabric you are
ironing.
2. The material is too dry to be
ironed.
1. Turn up the thermostat slightly
until the iron removes the
creases. Do not set the iron
temperature higher than what
is advised on the garment.
2. Use the spray button to
dampen the crease.
