7
ASSEMBLY INSTRUCTIONS
Fan Assembly
• Position the rear guard over the motor shaft, ensuring that the notches are
correctly aligned and then secure in place with the four screws.
• Align the fan blade with the flat part on the motor shaft and slot into place
and secure by tightening the fan blade screw fully.
• Position the front guard against the rear guard and hold together, close each
clip and then tighten the screw and the nut at the bottom of the guard.
Stand Assembly
• Insert the pole (inner and outer tube) into the base.
• Carefully tilt, so that the pole and the base are lying horizontally on the floor.
• Slot the base weight onto the bottom of the base
• Place the nut slice onto the bolt and then screw into the bottom of the base
weight, tighten securely.
• Return the stand to an upright position.
• Unscrew the height adjustment lock and pull up the inner tube to adjust the
height, ensuring that the lock is fully tightened before proceeding.
• Position the fan head motor either side of the pole as shown in fig 2 and
insert the tilt control bolt through the square hole of the bracket and the
lower holes of the inner tube.
• Fully tighten the small screw that is already located in the bracket and then
fit the knob onto the tilt control bolt and lightly tighten.
• Insert the position knob through the top hole of the bracket, adjust the fan
head to the desired position and firmly tighten both position and tilt control
knobs.
