15
Blinks each time data is stored to the static file.
When the receiver turns on:
All LEDs will flash.
The
Blue
SV’s
LED will flash three times, then after 1-
second, once more.
The
Red
Power LED will flash three times.
After the
Blue
SV’s
LED flashes three times, the receiver
will automatically begin searching for satellites. When
enough satellites are found to determine the receiver
position and current date/time, a new occupation file is
opened and the
Yellow
Files
LED will begin to flash,
once each epoch (the default epoch is 5-seconds.)
NOTE: If the receiver is deployed after not being used for
more than a month, or was last turned on more than a
couple hundred miles from the current location, it may
take an extra few minutes for the receiver to obtain a
position.
NOTE: if the
Yellow
LED is not blinking, then the receiver is
NOT collecting data. If you have waited a few minutes and
the receiver is not collecting data, something is wrong.
After the
Blue
SV’s
LED flashes three-times, you may plug
the receiver into your PC and it will mount as a fixed USB
drive.
To turn the iG3s off, press and hold the
On/Off
button for
one second. All four LED’s will quickly flash three times and
the receiver will power down.
NOTE: If the two right LEDS (Green and
Yellow
) flash at
the same time, then the flash memory has been
corrupted (typically by removing the cable while
downloading data.) Check the troubleshooting section
at the end of this manual for instructions on fixing this
issue.
