Page
6
of
6
Battery and Charging Procedure
BTR006L uses a rechargeable battery. A normal charging process takes about
2.5 hours. The red LED will turn on when charging and will turn off when
charging is finished. Do not charge for longer than 3 hours. This will shorten the
lifetime of the battery.
Plug the USB cable into a PC/Laptop USB port or suitable 5.0V USB power
charger. Using any incorrect power supply device will cause damage and void
the warranty.
Should the unit become hot to touch or emit smoke, switch off at the mains,
disconnect and contact the manufacturer.
After charging has finished, please remove the cable from the receiver. Do not
charge the receiver for long periods of time.
When the battery is nearly used up, the red LED will flash once every 20
seconds and you will hear 3 audible tones. Please charge the receiver at this
time.
Please make sure the battery has been fully charged and fully discharged for the
first three uses to ensure optimum battery performance.
Do not use the receiver in too hot or too cold environments. It is recommended
to keep the environment temperature between 15°C and 25°C.
Dot not connect, place or use the receiver near any source of heat such as a
cooker, radiator, oven, toaster, coffee maker or other apparatus (including
microwave ovens) that gives off heat. Do not use in direct sunlight.
Do not attempt to remove the battery from the receiver.
IMPORTANT WARNING: Do not connect to a PC or USB charger if
receiver is damp or wet. Danger of electrocution.
www.igadgitz.com
igadgitz™ is a registered trademark of INNOV8 GB Ltd. All rights reserved.
Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by the manufacturer is under license. Other trademarks and
trade names are those of their respective owners.
