Rev. 1.0
Page 9
1. Remove the connector kit from the Evaluation Kit and Connect the N-
BNC adapter to the COM-120B’s T/R RF IN/OUT connector located
in the lower left corner of the instrument.
2. Remove the TNC-BNC adapter from the Evaluation Kit and connect
the COM-120B’s Antenna Input located in the upper right corner of
the instrument.
3. Connect the AC Line cord to the COM-120B’s rear panel receptical
and apply power with the power switch located in the lower left corner
of the instrument.
The COM-120B will begin it’s power on sequence followed by a selftest.
The Selftest can be aborted by pressing a mode key such as [
REC
].
The COM-120B should be preset to factory
default conditions prior to performing any of
the following procedures. To do this, press
the [
SETUP
] key to access the system
setup screen.
Press the down arrow key until item 12 is
selected as indicated by the cursor box.
Press the [
ENTER
] key to activate Factory
Defaults.
Summary of Contents for COM-120B
Page 1: ...Rev 1 0 Page 1...
Page 2: ...Rev 1 0 Page 2...
