IFM ZB0929, Operating Instructions Manual, Page: 10 / 28

ZB0929 Gateway
10
8 Set-up
The device switches on automatically when connected to the power supply.
The device’s status LED indicates whether the device can access the set PING address.
Recommendation:
Take the address of the backend used (e.g. the MQTT broker) as PING address in order to be
able to visually check the connection status.
Status LED Colour State Meaning
Green On The device can access the set ping address and is con-
nected to the Internet/network.
Blue On The device starts up.
Flashes The device is in local configuration mode.
Red On The device cannot access the set ping address and is not
connected to the Internet/network.
u Open the configuration mode and check the settings.
8.1 Gateway configuration
In order to activate the configuration mode, make sure the device start up is completed. Observe the
status LED, which is either red or green, for this purpose.
u
Press the configuration key for at least 10 s until the status LED flashes blue.
w
The device opens a wireless LAN access point.
w
The serial number and password for the initial set-up is on the type label on the back of the
gateway.
u
Connect PC, smartphone etc. to the wireless LAN access point. The name of the wireless LAN
access point is "ifmgw-[serial number]".
u
Enter the password.
w
Windows 10 may ask for a PIN code as primary access point password. Use the option
'password'.
u
Open the browser on the PC, smartphone, etc.
u
Open the address 192.168.0.1:3001 in the browser.
w
No HTTPS command can be used to open the gateway’s web server (http://... is not
possible).
w
As of firmware 6.x, the address 192.168.0.1 must be used without indicating a port.
w
If the gateway’s LAN connection is already configured with a static IP in the address space
of 192.168.0.xxx and the gateway is connected to the PC via Ethernet, the configuration
interface is accessible at 192.168.1.1(:3001).
u
Make the necessary configurations.
(E.g. change password for gateway access, check error log, set up connection via wireless LAN,
LAN or mobile network or make MQTT broker settings → chapter “Connecting to the Internet /
network”).
u Restart the gateway by pressing [Quit].