![background image](http://html1.mh-extra.com/html/ifm/sd6020/sd6020_operating-instructions-manual_3954159034.webp)
34
9 Set-up
After power on and expiry of the power-on delay time of approx� 1 s, the unit is in
the Run mode (= normal operating mode)� It carries out its measurement and eval-
uation functions and generates output signals according to the set parameters�
• During the power-on delay time the outputs are switched as programmed:
-ON with normally open function (Hno / Fno)
-OFF with normally closed function (Hnc / Fnc)
-OFF for consumed quantity monitoring (ImP)
• If output 2 is configured as analogue output, the output signal is at 20 mA
during the power-on delay time�
10 Parameter setting
CAUTION!
The housing can heat up considerably�
> Risk of burns
►
Do not touch the device with your hands�
►
Use another object (e�g� a ballpoint pen) to carry out settings
on the unit�
Parameters can be set before installation and set-up of the unit or during opera-
tion�
If you change parameters during operation, this will influence the function
of the plant�
►
Ensure that there will be no malfunctions in your plant�
During parameter setting the unit remains in the operating mode� It continues to
monitor with the existing parameter until the parameter setting has been complet-
ed�
The parameters can also be set via the IO-Link interface�
Functions which can only be set via the IO-Link interface:
→ 4.9.1
�