![IFM PN7160 Operating Instructions Manual Download Page 15](http://html1.mh-extra.com/html/ifm/pn7160/pn7160_operating-instructions-manual_4146539015.webp)
15
UK
8.2 Explanation of the menu
8.2.1 Explanation of menu level 1
SPx/rPx Upper / lower limit for system pressure at which OUTx switches with hysteresis
setting� SPx/rPx is displayed if the parameter [Hno] or [Hnc] was set for OUTx
in the menu Extended Functions "EF"�
FHx/FLx Upper / lower limit for system pressure at which OUTx switches with window
setting� FHx/FLx is displayed if the parameter [Fno] or [Fnc] was set for OUTx
in the menu Extended Functions "EF"�
EF
Extended functions / opening of menu level 2�
8.2.2 Explanation of menu level 2
rES
Restore factory setting�
ou1
Output function for OUT1:
• Switching signal for the pressure limits: hysteresis function [H ��] or window
function [F ��], either normally open [� no] or normally closed [� nc]�
• Output off [OFF] (function only available in operating mode [3])�
ou2
Output function for OUT2:
• Switching signal for the pressure limits: hysteresis function [H � �] or window
function [F � �] as normally open [� no] or normally closed [� nc] each�
• Output off [OFF] (function only available in operating mode [3])�
dS1 / dS2 Switching delay for OUT1 / OUT2�
dr1 / dr2 Switch-off delay for OUT1 / OUT2�
uni
Standard unit of measurement for system pressure (display):
[bAr] / [mbar] / [MPA] / [kPA] / [PSI] / [inHG]�
The selectable units of measurement depend on the respective unit�
See table Setting ranges
�
P-n
Output logic: PnP / nPn�
Lo
Minimum value memory for system pressure�
Hi
Maximum value memory for system pressure�
dAP
Damping of the measured signal�
coLr
Assignment of the display colours "red" and "green" within the measuring
range�
cFH / cFL Upper / lower value for colour change� Parameter only active after selection of
a freely definable colour window in the coLr parameter: [r-cF] or [G-cF]�
diS
Update rate and orientation of the display�
CMPT
Selection of the operating mode