15
ifm
Programming Manual BasicController relay CR0431 v03.03.00
05 / 2018
System description
Hardware description
>
Binary inputs
1015
7345
The binary input can be operated in following modes:
• binary input plus switching (BL) for positive sensor signal
• binary input minus switching (BH) for negative sensor signal
Depending on the device the binary inputs can configured differently. In addition to the protective
mechanisms against interference, the binary inputs are internally evaluated via an analogue stage.
This enables diagnosis of the input signals. But in the application software the switching signal is
directly available as bit information
In = pin binary-input n
(CR) = device
(1) = input filter
(2a) = input minus switching
(2b) = input plus switching
(3) = voltage
Figure: basic circuit of binary input minus switching / plus switching for negative and positive sensor signals
In = pin binary input n
(S) = sensor
In = pin binary input n
(S) = sensor
Basic circuit of binary input plus switching (BL)
for positive sensor signal:
Input = open
signal = low (GND)
Basic circuit of binary input minus switching (BH)
for negative sensor signal:
Input = open
signal = high (supply)
For some of these inputs (
→ data sheet) the potential can be selected to which it will be switched.
Summary of Contents for ioControl CR2050
Page 228: ...228 10 Notizen Notes Notes ...
