io-key
10
>
4.4
Digital outputs
59402
The device has 2 digital switching outputs. The digital outputs are at pin 2 and pin 4 of the power port.
The outputs refer to the potential of the device supply US (pin 3).
The outputs are controlled via the switching function of the AIK001 (
→
edge switching function
(
>
59403
The device displays the following indications:
•
Status display of the voltage supply
•
Status and activity indication of the mobile radio connection to the ifm cloud
•
Status and error indication of the IO-Link ports
>
4.5
edge alarm function
59404
The device offers an alarm function. The function allows to define alarms based on rules that are sent
to the ifm cloud and which are independent of the selected mobile radio transmission interval.
The function can be configured via the ifm cloud and loaded to the AIK001 via mobile radio. The
configured alarms are processed directly on the AIK001, irrespective of the connection to the ifm
cloud.
Due to the nature of the Internet, it cannot be fully guaranteed that the AIK001 will send the
set alarm to the ifm cloud under all circumstances and within a specific minimum time.
Normally, the sensor value and alarm transmission takes place within a few seconds.
Details on the configuration:
→ Online help of the ifm cloud
>
4.6
Edge switching function
59405
The device offers a switching function. The function allows rule-based definition of conditions in which
one of the digital outputs of the AIK001 will be switched.
The switching function can be configured as:
•
threshold function (with hysteresis)
•
window function
The switching function can be configured via the ifm cloud and loaded to the AIK001 via mobile radio.
The switch function is processed directly on the AIK001 independent of the connection to the ifm
cloud.
Details on the configuration:
→ Online help of the ifm cloud
>
