IFM EIO104, Operating Instructions Manual

Page: 13 / 15

Converter IO-Link sensor ‒ 4…20 mA EIO104
13
Parameter Function Values
uni.P
(PRES)
Unit for pressure • bar
• MPa
• kPa
• PA
• Psi
• Mbar
• inH2O
• inHg
uni.L
(LEVL)
Unit for level • m
• µm
• mm
• cm
• inches
uni.C
(COND)
Unit for conductivity • µS/cm
• S/m
• mS/cm
uni.D
(DIST)
Unit for distance • m
• µm
• mm
• cm
• inches
uni.D
(FRQ)
Unit for frequency • Hz
• rpm
uni.A
(ACC)
Unit for acceleration • m/s
2
• g
• mg
uni.S
(SPEED)
Unit for speed • m/s
• fts
• mm/s
• in/s
FOU1 / FOU2 Behaviour of the analogue output OUT1 / OUT2 in case of
a fault:
• On: The analogue signal goes to 21.5 mA.
• OFF: The analogue signal goes to 3.5 mA.
• On
• OFF
Tab. 3: Adjustable parameters
* The sequence of process data values to be read out is defined in the IODD of each sensor, For
example, when a pressure sensor is connected and [SEL1] = PDV1 is selected, the pressure value will
be provided at output 1.
If a sensor has only one process value:
u
Set the value PDV1 for [SEL1] and [SEL2].
When changing the parameter [uni] from % to an absolute unit of measure and vice versa, the
values [ASP] and [AEP] will not be not converted via the parameter setting software. The values
programmed last are preserved.