6
3
Set the sensitivity without object�
Press once
►
The yellow and green LEDs go out for approx� 1 s�
>
After approx 3 s the green LED is on�
>
The unit is in the operating mode�
>
You can also proceed in reverse order: first setting without the object, then with
the object�
* The sensitivity can also be set in exactly the same way using the programming
wire (pin 2 / WH)� To activate the functions the programming wire is connected for the
appropriate time to L+ (pin 1 / BN) for PNP units or to L- (pin 3 / BU) for NPN units�
Feedback: If setting was not successful via the programming wire, the output will switch for
2 s� The unit then reverts to the operating mode with the sensitivity unchanged�
If the setting of the sensitivity is not possible (e�g� object signal and
background signal are about the same), the red LED flashes after step 3
for approx� 2 s� The unit then passes into the operating mode with the
sensitivity being unchanged�
If the setting button is not activated for 15 minutes during the programming
process, the unit passes automatically into the operating mode with the
sensitivity being unchanged�
Setting of the sensitivity with moving objects*
1
Activate the programming mode of the unit�
►
Press for about 2 s
►
until the red LED flashes�
The red LED goes out; the yellow and green LEDs flash alternately�
>
The unit is in the programming mode�
>